How to Set Up Linksys Router Through Ethernet Cable?

Set Up Linksys Router Through Ethernet Cable

Linksys Router can be set up either with the help of Installation CD or by manually configuring Linksys Routers Settings. Before starting the Linksys Router setup Process make sure you have an Internet connection in your Modem. You can check that by connecting your modem with an ethernet cable to your computer and then try to go online. IMP: In order to the setup use Linksys Router, first reset it by pressing the factory reset button for 10 seconds.

Steps to be followed Setup Linksys Router:-

  • Connect the cable from the modem to the back of Linksys router’s WAN port. (WAN is always different from the other 4 ports)
  • Join Ethernet from your computer to any of the Linksys router’s LAN ports. In case you have a WiFi-equipped computer, you will still need it to connect with Ethernet
  • Now plug in Linksys Router to the power outlet.
  • Login into the router setup page by typing (extenderlinksyssetup.com / extender.linksys.com or 192.168.1.1 in the address bar) of your browser.
  • It will now prompt you for Username and Password. Leave the Username tab blank and type “admin” in the password tab.
  • Once logged in click on the Setup tab and then click MAC Address Clone.

IMP: A Media Access Control (MAC) Address will allow your Internet Service Provider to recognize the router as the computer with the registered MAC Address.

  • Click on Clone My PC’s MAC.
  • This will enable your Internet status and you will be good to go.

NOTE: DHCP should be your Internet Connection Type.

To check your internet status, firstly check your Internet IP Address. Numbers on the field mean that the router has been configured. Otherwise, click on RELEASE IP and RENEW IP.

Linksys Release Renew IP
Linksys Router Setup, Release Renew IP
  • Your Linksys router will start providing internet now.
  • In case it does not, Power cycles your modem, Linksys router, and computer.
    First, turn off the modem then the Linksys router, and lastly your computer. Wait for around 60 seconds and turn on the Modem first. Now, wait till all the lights on the modem lit. Now, turn on the Router and let it boot up properly, and wait till all the lights are up on this one too. Lastly, at the very end turn on the computer and try to go online. Make sure your Ethernet is still connected from router to computer or if your computer supports WiFi try connecting it to your Linksys router’s SSID wirelessly.

Leave a Reply

Your email address will not be published. Required fields are marked *